API standard 650 liquid storage tanks weld metal

Low-pressure storage tanks for Liquefied Hydrocarbon Gases
API standard 650 liquid storage tanks Primary Components: In general, primary components include those components that may be stressed to a significant level, those whose failure would permit leakage of the liquid being stored, those exposed to a refrigerated temperature between –60°F and –270°F, and those that are subject to thermal shock. The primary components shall include, but will not be limited to, the following parts of a single-wall tank or of the inner tank in a double-wall tank: shell plates; bottom plates; roof plates; knuckle plates; compression rings; shell stiffeners; and manways and nozzles including reinforcement, shell anchors, pipe, tubing, forgings, and bolting.

Oil, Gas, Chemical, Water, and Bio-Fuel storage. Maximum of the most common welded steel tanks used in industry are designed following API 650. Tanks typically found in Refinery API standard 650 liquid storage tanks tank farms, Terminals, Pipelines, and other process facilities use these tanks.

In 2016. Our company offer 1200 tons API 5L GR.B hot rolled coil to Bangladesh——100 tons for 3.9*625mm, and 1100 tons for 7*683mm. It is one tender project, we get the tender at the end of 2015, and arrange the production in 2016. They required the tolerance of thickness is +0.1/-0.2mm, and width tolerance is +/-0.5mm, which is a very high requirement for coil tolerance, but our mill handling this very well. and our Q/C department witness all of the process.

High temperature heat transfer oil fin tube heating device for large API standard 650 liquid storage tanks has the advantage of high heat transfer efficiency. The high-temperature heat-conducting oil finned tube heating device adopts high-efficiency outer finned tubes. The outer finned tube coils are immersed in a water bath. Compared with ordinary light tubes, the contact area between the evaporation coils and the medium is increased. The total heat transfer coefficient of the coil is determined by the heat transfer coefficient outside the tube. This increases the heat flux per unit tube length and improves the overall heat transfer efficiency.

We have a professional after-sales service team, the company has developed a clear service process and service standards, after-sales service team members strictly perform after-sales procedures, comply with service standards. The most important thing is that we have set up the correct concept of after-sales service, "customer first, sincere service for users".