API standard 650 insulated tanks flush-type cleanout fittings

The company regularly holds sales elites to share experiences, to promote the rapid growth of colleagues, and achieve the company and employees. The company conducts employee skill training and related knowledge video learning from time to time. All these things is to improve the employees' skills and literacy, and reflects its own value. It has always been the pursuit of BBN steel to enhance the employee’s ability and keep up with the times.In addition to the requirements of API Standard 620 tank Appendix Q.8.1, the nameplate shall be attached to the tank at an accessible location if it is outside of any insulation or protective covering of the tank. The nameplate for the inner tank shall be located on the outer tank wall but shall refer to the inner tank. The nameplate, if any, for the outer tank of a double-wall tank shall be located adjacent to the nameplate or the inner tank and shall refer to the outer tank.API 650 is widely used for tanks that are designed to internal pressures of 2.5 PSI or less and store products such as crude oil, gasoline, chemicals and API standard 650 insulated tanks produced water. Advance Tank has extensive experience with API 650 tanks ranging in diameter from 8' - 300' for refineries, terminals, pipeline facilities and other clients.Based on the principle of “sincerity and win-win cooperation”, our company keeps forging ahead. In the fierce market competition, we have won the trust and rapid development of our customers with good cooperation and sincere service spirit. With pioneering spirit, the pursuit of excellence, continuous learning, and never satisfied content, we will create a win-win situation with our customers to create a better future. The company has sufficient inventory and complete varieties and specifications.Due to irregular operation of API standard 650 insulated tanks welding, there are many weld deformations during the construction process. Before specific operations, most construction units have formulated relatively complete construction plans and set up special welding process instructions, but the operators have not fully performed welding in accordance with various process guidance requirements and construction specifications, resulting in some quality problems of oil storage tanks. How can we reduce or even avoid this kind of situation?