API standard 650 ground supported liquid storage tanks decks

The API standard 650 ground supported liquid storage tanks external floating roof tank of API 650 tank has many advantages, and its application range is more and more wide. It is a kind of storage tank with a bright future. The well-designed internal floating roof tank of API 650 tank is the best and least investment method to control evaporation loss of API standard 650 ground supported liquid storage tanks Fixed roof tank.

The main contents of safety inspection for atmospheric storage tank, API standard 650 ground supported liquid storage tanks are to see whether the tank foundation is sunk, whether the tank is corroded, whether there are cracks in the tank body and bottom, whether there is concave convex phenomenon on the top and wall of the tank, whether the accessories of the storage tank are in good condition, etc. After the API standard 650 ground supported liquid storage tanks safety inspection and detection, the defects found in the tank should be handled according to the inspection rules in time to ensure the normal and safe use of the storage tank in the later stage.

The API standard 650 ground supported liquid storage tanks stiffener ring and backing strip (if used) are primary components, and they shall comply with the requirements of API 620 storage steel tank Q.2.1. The stiffener rings may be fabricated from plate using an intermittent weld on alternating sides between the web and the flange.
Except for aluminum or stainless steel tanks, all fillet welds shall consist of a minimum of two passes. The ends of the fillet welds shall be 2 in. from the rat hole (see Figure Q-1), and these welds shall be deposited by starting 2 in. from the rat hole and welding away from the rat hole. An acceptable alternative to the detail that includes stopping fillet welds 2 in. short of the rat hole would be to weld continuously through the rat hole from one side of the stiffener to the opposite side. All craters in fillet welds shall be repaired by back welding.

The quality inspection department is responsible for the inspection management of raw materials and finished products, and the quality inspection and acceptance of products and raw materials. Strictly abide by the company's management system, conscientiously exercise the management power given by the company, and put an end to all ultra vires; be responsible for the inspection of all kinds of raw materials entering the company, and put forward quality problems and handling opinions.

In particular, the EU imports a large amount of iron ore from central and South America and Oceania, which are mainly transported by sea. The perfect port infrastructure makes the port operation cost of EU iron ore raw materials import relatively low. However, the API standard 650 ground supported liquid storage tanks steel transportation between EU Member States is mainly railway transportation, and the EU member states have established a very developed railway network and railway information infrastructure.