API standard 650 fixed roof tanks appurtenances

In this project, an area of tank wall is constructed of ASTM A285, Grade C, steel plate that is 5/8-in. thick and has spot-radiographed, double-welded butt joints. The wall is subject to tension in a meridional direction and to compression in a latitudinal direction. The values of R1 and R2 at the point under consideration are 75 in. and 300 in. respectively. A corrosion allowance of 1/16 in. is required. The computed (meridional) tensile stress, stc, in the net thickness after deduction of the corrosion allowance is 6000 lbf/in.2.
The problem in this example is to find the maximum allowable (latitudinal) compressive stress value for the given conditions, in conformance with the provisions of API 620 tank standard 5.5.4.5.

The API 650 petroleum storage tank standard is one of the most widely used design specifications. It is the API 650 standard of the American Petroleum Institute. The main goal of the API 650 standard is to promote the purchase and construction of vertical, above-ground, and welded manufacturing API standard 650 Fixed roof tanks tanks through the requirements contained in its parts to ensure that the required safety regulations are met.

The cone slope of the completed API standard 650 fixed roof tanks foundation is 15/1000 for the general foundation and less than 35/1000 for the soft foundation. After the foundation settlement of the storage tank is basically stable, the surface slope must be greater than eight thousandths. The edge of the tank bottom should be more than 0.3 meters higher than the surrounding ground. Above the ground, the tank bottom leakage detection tube should be drawn from the foundation sand cushion and cross the foundation ring wall or the slope protection surface. The circumferential distance should be less than 20 meters, and each API standard 650 fixed roof tanks should have at least 4 detection tubes.