API standard 650 duplex stainless steel tanks toughness procedure of plates

API standard 650 duplex stainless steel tanks Breathing valve: The function of the oil tank breathing valve is to adjust the oil and gas pressure in the tank. When the pressure in the tank is too high, part of the excess oil and gas will be discharged through the breathing valve to reduce the pressure in the tank; when the pressure in the tank is too low, through breathing The valve sucks in air from the outside of the tank to increase the pressure in the tank and keep it constant with the atmospheric pressure. The breathing valve is usually installed at the top of the oil tank.

Surface Inspection of low-pressure storage tank Component PartsBefore assembly, unless already so certified by shop inspectors, all sidewall plates or sections and roof and bottom plates shall be inspected for thickness, freedom from injurious defects, and soundness of any welded joints.Check of Dimensions of API standard 650 duplex stainless steel tanks Component PartsAll formed plates and curved sections shall be checked for conformance with the planned dimensions and cross section. For unusual repairs the inspector should keep a record of measurements taken at sufficient intervals to constitute a satisfactory record.Check of Chemical and Physical Property DataThe inspector shall check the material being assembled by the lists of the plates from the mill, their heat numbers, chemical analyses, and mechanical properties as given on mill reports and shall see that copies are available to be attached to the Manufacturer’s report.

The outer layer of API 650 tank is glass fiber reinforced plastic layer with a thickness of more than 2.5mm, which API standard 650 duplex stainless steel tanks has strong corrosion resistance and electric corrosion resistance. Special process technology is used between the two layers to make the gap reach 0.1 mm, so as to eliminate the existence of potential safety hazard from the root.