API standard 650 aluminum tanks anchor straps
In this project, the area of tank wall used is of the same construction, material, and geometry as that described in F.1.3.1 except that the thickness of the plate is 3/8 in. The wall is stressed in the same manner as is described in F.1.3.1. A corrosion allowance of 1/16 in. is required. The computed (meridional) tensile stress, stc, in the net thickness after deduction of the corrosion allowance is 8000 lbf/in.2.The problem in this example is to find the maximum allowable (latitudinal) compressive stress value for the given conditions, in conformance with the provisions of API 620 tank standard 5.5.4.5.Solution: As determined from Table 5-1, the maximum allowable tensile stress value, Sts, for ASTM A285, Grade C, steel plate in simple tension is 16,500 lbf/in.2. Since the compressive stress is latitudinal, the governing value of R in this situation is R1, or 75 in.
The interior of API 650 storage tanks to be internally lined or coated must have all edges rounded to a minimum of 3 mm radius. Internal welds must be completely seal welded, ground smooth, and free from API standard 650 aluminum tanks surface porosity, pockets, and high spots. Remove weld spatter. Vendor as specified on API 650 storage tanks drawing must perform additional surface preparation.
In 2018, one of our India customers visit Zhengzhou office building and work shop to discuss carbon steel Q235B grind plate technical request. They have strict surface and thickness tolerance, and they also request UT and MT for testing for Q235B grind plate. As a result, they purchase 179 tons as trial order for first cooperation. After using the gind plate, the India customer has good comment on our API standard 650 aluminum tanks quality. Till now, we keep exporting around 100 tons per month as regularly.
}API standard 650 aluminum tanks weld tightness test: remove dirt from the API standard 650 aluminum tanks weld, apply white powder emulsion, spray kerosene on the other side of the weld after drying. Because of the strong penetration of kerosene, if kerosene is sprayed after 12 hours (under low temperature conditions, the time can be extended), if the surface of the welded seam coated with white emulsion has no spots, the welded seam meets the requirements.
Respect customers and treat each other sincerely. Customers are always right. Always remember that the user is the God of the enterprise, respect the customer, and accept the customer's opinion modestly is the guarantee of the long-term development of the enterprise. Adhere to this concept, so that the service and the product are the same, long-term.
