API 650 unanchored flat-bottom tank bleeder vents

The working pressure of the low-pressure storage tank is greater than that of the atmospheric storage tank, but its pressure is less than 0.1MPa. API 650 petroleum storage tanks are classified according to their environment: Above-ground storage tank: refers to the bottom of the storage tank at the design elevation of API 650 unanchored flat-bottom tank and above; the bottom of the tank is below the design elevation of +0.00 but not exceeding.

The company's logistics team adheres to the development concept of “gathering advantages, providing superior services, creating value, and leading the market”, and tightly focuses on the strategic positioning of “developing large-scale steel logistics and building large-scale steel supermarkets”. Facing the whole country and integrating into the world to build an "one center, one network" international circulation system. Through the development of 5-10 years, it is expected to form a modern steel industry with annual operating income exceeding 2.5 billion yuan.

Based on the principle of “sincerity and win-win cooperation”, our company keeps forging ahead. In the fierce market competition, we have won the trust and rapid development of our customers with good cooperation and sincere service spirit. With pioneering spirit, the pursuit of excellence, continuous learning, and never satisfied content, we will create a win-win situation with our customers to create a better future. The company has sufficient inventory and complete varieties and specifications.

Treatment of API 650 unanchored flat-bottom tank welding defects:
1. Lack of fusion: once found, it should be shoveled and grinded off before re welding.
2. Incomplete penetration: over standard defects shall be removed and re welded. When welding on both sides, the shallow side of the groove can be grinded and shoveled to expose the welding root on one side, and then the welding is repaired.
3. Slag inclusion: over standard defects shall be removed and re welded.
4. Crater: weld to full after grinding.
5. Air hole: if the internal air hole exceeds the standard, it shall be welded again after being removed by grinding shovel, and the surface air hole shall be removed by grinding wheel and then repaired.