API 650 SUG II tanks metal-seated ball valve

Soil Structure Interaction: Soil structure interaction per API 650, Section E.6.1.6 may be used for OLE design providing the damping ratio does not exceed 10 %.
Allowable Stresses
Design allowable stresses shall be per API 620 large welded steel storage tank, Section Q.3.3, including the 33 % increase permitted for earthquake loads.
Self-anchored Inner Tank
The anchorage ratio for a self-anchored inner tank, J, shall not exceed 1.0 for the OLE design combination to limit uplift and stresses in the annular plate and corner weld.
Foundation Stability
The overturning ratio defined in API 650, Section E.6.2.3, Equation (E.6.2.3-1) shall be equal to or greater than 3.0 for the defined OLE event.

The interior of API 650 storage tanks to be internally lined or coated must have all edges rounded to a minimum of 3 mm radius. Internal welds must be completely seal welded, ground smooth, and free from API 650 SUG II tanks surface porosity, pockets, and high spots. Remove weld spatter. Vendor as specified on API 650 storage tanks drawing must perform additional surface preparation.

In 2014, we offered 175 ton Cold rolled stainless steel plate to Thailand. The API 650 SUG II tanks products are from TISCO. Here is the MTC that we offered to customer. We have our own quality team. Our quality team will inspect every order before shipment for customer. Normally, we will test the chemical composition, thickness, width, and length. Here are some pictures for last inspection.

Prefabrication requirements of large vertical API 650 SUG II tanks accessories: the prefabrication shall be deepened as far as possible in strict accordance with the requirements of construction drawings and specifications, according to the principle of convenient installation and construction, as much as possible to reduce the installation workload, especially the workload of high-altitude operation. The prefabricated accessories shall be strictly inspected to ensure the quality and make marks. In addition, effective measures should be taken to prevent deformation, damage and corrosion during storage, transportation and stacking on site.

The company formulates clear service process and service standard. To do a good job in after-sales service, first of all, clear service process and service standards should be formulated to let employees know which procedures to perform and which service standards to abide by.