API 650 petroleum storage tanks landing legs

In order to prevent the deformation of the bottom of metal vertical API 650 petroleum storage tanks during welding, comprehensive control measures such as strict control of assembly geometry size, reasonable welding procedure, process control of welding deformation and rigid fixation are adopted during assembly welding. The specific methods are as follows:
1. Strictly control welding groove forming of API 650 petroleum storage tanks.
2. Strictly control the size of tank welding seam assembly.
3. Define the welding sequence of tank bottom plate.
4. Reasonable distribution of welders.

Accept the inquiry from the owner of the goods and the inquiry by sea: master the port and price from the port of shipment to all continents and routes, and the port and price that the owner often needs to serve; the shipping schedule information of the main shipping companies; when necessary, ask the owner of the inquiry for some category information, such as the name of the goods, the level of danger, etc. (water hazard code).

Our quality and service commitment: API 650 petroleum storage tanks product quality problems, life-long replacement.In the process of using, any time if you find we supplied steel materials not conform to the requirements of technical standards, we can replace it for you free of charge. However, it should be noted that non product quality problems caused by improper use are not covered by the warranty. Please pay attention to the service time commitment as well as the product quality assurance commitment. Because only the products of big brands and reliable enterprises with complete after-sales service system can truly realize the long-term product quality assurance and the whole process of service.

Charpy V-notch specimens shall be taken from the weld metal and from the heat-affected zone of the welding procedure qualification test plates or from duplicate test plates.
Weld metal impact specimens shall be taken across the weld with the notch in the API 620 oil tank material weld metal. The specimen shall be oriented so that the notch is normal to the surface of the material. One face of the specimen shall be substantially parallel to and within 1/16 in. of the surface.