API 650 insulated tanks wind girders

Generally speaking, the duration of the "exhalation" of the API 650 insulated tanks is longer than that of the "inhalation" of the API 650 insulated tanks every day. There are many factors affecting the "small breathing" loss, mainly including the following points: the change of temperature difference between day and night, sunshine time of the API 650 insulated tanks location, open area of the API 650 insulated tanks, atmospheric pressure, filling degree of API 650 insulated tanks, etc. When the API 650 insulated tanks is full of gas, the space volume is small, and the "small breathing" loss is less; if the space volume is large, the loss is also large.

Welding of API 620 Steel storage tank Primary Components
The following primary components shall be joined with double butt-welds that have complete penetration and complete fusion except as noted:
Longitudinal and circumferential shell joints and joints that connect the annular bottom plates together. When approved by API 650 insulated tanks Purchaser, these may be welded from a single side provided temporary non-fusible backing is used with complete penetration and complete fusion. Both sides of the joint shall be 100% visually examined as specified in 7.15.5.

The technology center has always been focusing on application research, improving market realization and scientific and technological contribution rate; taking user demand as the goal, highlighting the personalized development of products; taking the joint development of industry, University and research, and technology integration as the means, improving the starting point and level of innovation, and realizing the breakthrough of core technology; taking advanced research as the guide, pursuing the leap of technological development.

According to API 650 tanks, anchoring devices should be designed to transfer overturning moments to the API 650 insulated tanks tank foundation. At the same time, according to API 650 tank Appendix F, when the tank is to be anchored, the size of the anchoring parts is determined by the maximum lifting force caused by the internal pressure and wind load or the combination of internal pressure and seismic load.