API 650 aluminum storage tanks general requirements for delivery of plates

Thickness as it Affects Preheat and Post-heat Requirements
Plate with thicknesses below 1/2 in. is reasonably notch tough. In most steels, when the API 650 aluminum storage tanks used plate thickness exceeds 3/4 in. – 1 in., notch toughness, particularly as welded, decreases sharply. The decrease in notch toughness can be minimized by the conventional post-heat treatment and, in many steels, by preheat treatment. The benefits of preheat treatment in steels 3/4 in. – 1 in. thick have been demonstrated; similar benefits could be expected in thicker steels, but sufficient experimental data are currently lacking.

Oil, Gas, Chemical, Water, and Bio-Fuel storage. Maximum of the most common welded steel tanks used in industry are designed following API 650. Tanks typically found in Refinery API 650 aluminum storage tanks tank farms, Terminals, Pipelines, and other process facilities use these tanks.

Prefabrication requirements of large vertical API 650 aluminum storage tanks accessories: the prefabrication shall be deepened as far as possible in strict accordance with the requirements of construction drawings and specifications, according to the principle of convenient installation and construction, as much as possible to reduce the installation workload, especially the workload of high-altitude operation. The prefabricated accessories shall be strictly inspected to ensure the quality and make marks. In addition, effective measures should be taken to prevent deformation, damage and corrosion during storage, transportation and stacking on site.

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!