aluminum sheet 1060 API standard 650 stainless and carbon steel tank

Density of API standard 650 stainless and carbon steel tank Liquid Stored
The density of the liquid stored shall be its maximum density within the range of design temperatures, but no less than 29.3 lbf/ft3 for methane, 34.21 lbf/ft3 for ethane, and 35.5 lbf/ft3 for ethylene.
Design Metal Temperature
The design metal temperature of each component exposed to the liquid or vapor being stored shall be the lower of the temperatures specified as follows: The design metal temperature of the components of the API 620 single-wall tank or the inner tank of a double-wall tank shall be the minimum temperature to which the tank contents shall be refrigerated, including the effect of subcolony at reduced pressure.

Standard API 650 tank calls for calculations based on the specific gravity of the liquid product being stored. This permits the thickness of the steel API standard 650 stainless and carbon steel tank needed as well as other specifications of how the tank is built to be determined by the weight of the API 650 tank.

Due to irregular operation of API standard 650 stainless and carbon steel tank welding, there are many weld deformations during the construction process. Before specific operations, most construction units have formulated relatively complete construction plans and set up special welding process instructions, but the operators have not fully performed welding in accordance with various process guidance requirements and construction specifications, resulting in some quality problems of oil storage tanks. How can we reduce or even avoid this kind of situation?

Have a question? Get a Free Consultation

If you are interested in our storage tanks, you can get contact with us through online consulting, demand table submission, e-mails and telephones.

Corporate Office

High-Tech Development Zone, Zhengzhou, China

Contact us

+86-371-86151527
[email protected]

Send a Message!