A537Cl1 plates API Std 650 welded steel storage tanks

API 650 is an American standard for welding flat bottom vertical storage tanks. This API Std 650 welded steel storage tanks standard specifies requirements for the design, manufacturing, welding, inspection and installation of storage tanks. API 650 is widely used in storage tanks designed to withstand low internal pressures and used to store typical products such as API Std 650 welded steel storage tanks crude oil, gasoline, chemicals and water. BBN has extensive experience in API 650 tanks, from +/- 500 cubic meters of tanks produced in the factory to +/- 15000 cubic meters of tanks produced on site.

The manufacturing requirements of bottom plate of vertical metal tank, API Std 650 welded steel storage tanks are as follows: 1. In order to compensate welding shrinkage, the layout diameter of tank bottom is 5-2mm than the design diameter; 2. The butt joint of edge plate of tank bottom shall be machined automatically or semi-automatically; 3. The distance between any two adjacent welding joints on the tank bottom plate and the distance between the butt joint of edge plate and the longitudinal weld of bottom ring wall plate shall not be greater than 200 mm.

Welding of API 620 Steel Storage Tank Primary Components
The following primary components shall be joined with double butt-welds that have complete penetration and complete fusion except as noted:
Longitudinal and circumferential shell joints and joints that connect the annular bottom plates together. When approved by API Std 650 welded steel storage tanks Purchaser, these may be welded from a single side provided temporary non-fusible backing is used with complete penetration and complete fusion. Both sides of the joint shall be 100% visually examined as specified in 7.15.5.

After comprehensive and professional training such as customer service, the customer service team has more strict discipline in the management of customer service team to ensure that customer service personnel respond to customers with a professional attitude. A process supervision system has been set up to let each customer supervise the process of the system with us

In view of the characteristics of container transportation, such as high added value, low cargo damage and short time, our company takes more consideration of port collection and distribution conditions, port facilities, flight density and route coverage when choosing ports. For the convenience of customers, as well as the safety of goods.