A285 Gr C plates API standard 650 carbon steel tank
Since the foundation of the company, the Spring Festival Gala is an annual activity held at the end of the year. Now it is a part of the BBN company culture to enrich the employee's life. The annual Spring Festival Gala in 2019 was held on January 20, 2020. There are opening ceremony, leader's speech, BBN steel performance, awards for outstanding employees, lucky draw, party game, curtain call, company group photo, annual Gala dinner and other links.
Prefabrication requirements for API standard 650 carbon steel tank, large vertical storage tanks:1. The machined surface of the edge of the steel plate should be smooth, and there should be no defects such as slag inclusion, delamination, cracks, etc., and the surface hardened layer produced by the flame cutting groove should be removed.2. Dimension deviation after steel plate processing: the deviation of plate width is less than 1.5 mm, the deviation of plate length is less than 2 mm, and the difference between diagonals is less than 3 mm.
Stamping of API 620 Storage Tank PlatesBefore plates required to be stamped by the steel mill are used, the inspector shall see that they bear the stamp. In laying out and cutting the API standard 650 carbon steel tank plates, at least one set of the original material identification markings should, if possible, be left where it will be plainly visible when the tank is completed. Should the identifying marks be obliterateSpot radiographic or ultrasonic examination shall be not less than 6 in. extending along the weld. Spot radiography shall comply with the standards given in 7.15.1.3. Where spot radiographic or ultrasonic examination is applied at joint intersections, the surface shall be prepared and examined for a distance of 3 in. on each side of the intersection, making the minimum length of examination 6 in. on the horizontal weld and 3 in. on the vertical weld.