5154 aluminum bar API 650 stainless steel storage tanks

API 620 Tank Standard Post-heat Treatment (Stress Relief)
The post-heat treatment now performed on pressure vessels is of established value, although the mechanism by which the improvement is realized may be open to debate. Post-heat treatment of API 650 stainless steel storage tanks tank sections when the plate thickness exceeds 11/4 in. is required as stated in 5.25. In special cases, the possibilities of post-heat treatment after erection should be explored. Post-heating an insulated tank may be possible if an ample source of heat is readily available and if the rigidity of the tank is adequate.
The thermal stress-relief treatment performed on pressure vessels is recognized as a means for reducing the probability of brittle failures.

The working pressure of the low-pressure storage tank is greater than that of the atmospheric storage tank, but its pressure is less than 0.1MPa. API 650 petroleum storage tanks are classified according to their environment: Above-ground storage tank: refers to the bottom of the storage tank at the design elevation of API 650 stainless steel storage tanks and above; the bottom of the tank is below the design elevation of +0.00 but not exceeding.

In 30th,Dec,2018--2th,Jan,2019, One Malaysian customer come to visit our factory to inspect their goods about CCS-AH36 steel plate. This customer is a famous shipyard in Malaysia. Their company has the business scope of tourism, API 650 stainless steel storage tanks shipbuilding, transportation and so on. As a terminal manufacturer, they have strict requirements on quality . After visiting our factory, the customer are very satisfied with the quality of this batch of products.

According to the standard of head of API 650 stainless steel storage tanks, there should be no crack, delamination, inclusion and other defects on the groove surface, which is consistent with the steel plate standard. The API 650 stainless steel storage tanks head polishing can adopt different technology according to different requirements, including rough polishing, medium polishing and fine polishing. Only the materials used for the third type of pressure vessels must be retested, and the materials used for the first and second class pressure vessels are not generally re inspected.

The after-sales service department will pay return visit to each customer by call or email, report problems found during the return visit in time, and discuss with the production and quality inspection center to propose effective solutions and follow up in a timely manner, so as to ensure the benefits each customer are fully guaranteed, and to provide customers with more value-added services.