45ft diameter API standard 650 mechanically-anchored tanks

Large Steel storage tank Anchorage
In addition to the loads in API 620 oil storage tank Q.4, Q.5.1, and Q.5.2, the anchorage for the tank that contains liquid, whether it be a single-wall tank or the inner tank of a double-wall tank, shall be designed to meet the requirements of Q.3.6.2 through Q.3.6.5. The anchorage shall accommodate movement of the tank wall and bottom caused by thermal changes. For anchored flat-bottom tanks, the anchorage shall be designed as described in Q.3.6.4.1 through Q.3.6.4.3.

According to API standard 650, the stairs used for API 650 petroleum storage tanks or thermal insulation tanks should be double longitudinal beams supported by a minimum of ribs. If the gap between the API standard 650 mechanically-anchored tanks tank shell and the stringer of the API 650 petroleum storage tank exceeds 200mm, handrails should be provided on both sides of the stairs. Unless otherwise specified, according to API standard 650 mechanically-anchored tanks ASTM A123, the following accessories shall be hot-dip galvanized. The damaged zinc coating should be repaired with zinc alloy.

LSAW Pipe to Peru. In the beginning of 2014, Peru government released an international tender for one of the hydroelectric power plant. Finally they chose us as the contractor, we purchased the steel plate and then fabricate the API standard 650 mechanically-anchored tanks steel plate into steel pipe, and then make the corrosion protect on the surface, we also supply the fitting with our steel plate, the total value of this order is about 2 million USD.

The API standard 650 mechanically-anchored tanks must go through strict inspection before putting into use. Inspection of plate groove of API standard 650 mechanically-anchored tanks, vertical oil tank: After finishing the groove processing of oil tank plate, it is necessary to conduct dye penetrant inspection on the groove. This process is mainly aimed at the hard damage of groove in the machining process and the defects of the plate itself. If any defect is found, it shall be processed again until the defect disappears.

First of all, we should establish a correct concept of after-sales service. Service concept is an important part of corporate culture and a long-term enterprise value concept. Our company's after-sales service embodies the concept of "customer first, sincere service for customers". As long as we are in the "sincere service for users" under the guidance of the idea, I believe we will get rich returns.